Hot
New

Deposit Photos Image

SKU:

PRODUCT TYPE:

$10.00

This product is added to the cart when the end-user uses the content from the Deposit Photos service.
Spend $150.00 to receive Free Shipping within Australia!
Design Services
Customer Service
RPM Installation guide
Design Services

Our professional designers can help create the look you want and bring your ideas to life.

Contact us now on 03 9882 4905 or sales@thecreativeprinter.com.au. Someone from our team will be in contact to discuss your needs.

Customer Service

We're here to help

Have a question? You may find an answer in our FAQs. But you can also contact us on 03 9882 4905 or email sales@thecreativeprinter.com.au

    RPM Installation guide

    All of our repositionable media (RPM) solutions are easy to install, remove, reposition and reapply without damage to surfaces. An information sheet with cleaning instructions and an installation guide will be sent out with every order.  

    Please follow these steps to ensure your RPM installation is quick and easy.

    • Before installation, ensure surface is clean and dry. Allow a minimum of 14 days for any freshly painted surfaces to dry completely. Filler must be dry (if you have recently fixed holes) and any lumps or bumps sanded back before installation as any imperfections will show through when looked at closely;

    • We recommend two people for installation if installing drops larger than 1100mm in width;

    • Peel back the top (approx 200mm) of RPM from the backing sheet and adhere exposed RPM to surface. Using the soft edge of the supplied applicator or a dry cloth, swipe left to right applying even pressure to adhere print. Pull backing away from print as you move down keeping the material taut. Continue moving down, encouraging air bubbles to the edge, until the entire print is adhered to the surface. If twisting or excessive air bubbles occur, lift off and start again;

    • Recycle backing sheet material;

    • Once entire sheet is applied, smooth over with applicator or your hand to ensure there are no air bubbles;

    • If required, trim off excess material (bleed) using a sharp Stanley knife.


    Should you have any questions about installation, or would like a list of accredited installers,
    please contact us on (03) 9882 4905 or email us at sales@thecreativeprinter.com.au

    Pre-loader